I changed 1 cell and charged the car.
Now i can drive 100 meters and after that car it stops with this errors:
U01A200
U01A2FA
P1600
C2900
P0DE7FB
P0DE6FB
I changed 1 cell and charged the car.
Now i can drive 100 meters and after that car it stops with this errors:
U01A200
U01A2FA
P1600
C2900
P0DE7FB
P0DE6FB
I found a module pack battery gen 4, is any possibility to fit this pack in my battery, my car is 2013 model?
I must find a module, i can’t change the cell🤦🏻♂️
Charged already 3 times
all other cells are staying at 3.56v from 3 weeks
I’ve had 4.2v, after 12 hours it goes to 3.15v after another 12 hours is 1.65v
I’m facing with the problem of that cell, is going under 3.2v in one night.
Probably I must change that cell.
There is any way to program bms to forget that cell?
Don’t forget that I need also the sensor
Successful charged the bad cell, now is at 3.59v I will wait few hours to see if it stays there.
Please tell me how to proceed to my next step?
I will try that, anyway be prepared to help me with the BMS and the sensor
If i will remove the connection of the broken cell and put one 3.6v 50 ah with wires connected on same connections like old old one you think it will work? Or the bms will read different resistance and wouldn’t recognize the new one.
Only 1 cell is 0.7v in rest all of them are above 3.5v
If I have 110v, 110v and 108v on each module I still measure each cell? Or is enough to resetbms and the sensor replaced?
If the battery is 325v and some cells are under 3,2 v it will work or is a lost cause?
This are the errors after charging
The BMS needs to be repaired, still have errors on, any help?
All the cell >3,2v meaning is balanced and stable?
Finally I successfully charged my HV battery to 330v, what value should I rich?
I will try like that, hope I will have luck
Already did that, my problem is to find a labor unit for charging. For HV 300-500v and 10A is difficult to find. No idea until now 🤦🏻♂️